3D Fun Printz Pen Holder 매뉴얼

{카테고리_이름} 3D Fun Printz Pen Holder에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Fun Printz Pen Holder 3 페이지. For cricut maker/air explore series.

Cricut Maker/Air Explore series compatible Universal Pen Adapter

Most importantly. The Pen Holder is partly made from PLA as it is a natural plastic originating

from corn starch and is recyclable. For these reasons it does not like heat.

Please don't leave it in the sun, on a hot windowsill, on or near a radiator or anywhere else with

Please also keep away from children and animals. PLA can be sharp when broken.

NEVER TRY AND ADJUST THE SCREW WHILE THE HOLDER IS IN YOUR MACHINE. YOU

WILL DAMAGE YOUR MACHINE. ALWAYS FULLY REMOVE THE HOLDER BEFORE

DO NOT FLEX THE TIPS BY HAND. THEY ARE DESIGNED TO MOVE VERY SLIGHTLY TO

ACCEPT A PEN NIB. FORCING A PEN BODY ALL THE WAY THROUGH THE TIP OR

There are 2 pen holders in the kit. One is marked with an "S" and has a bigger opening for

pens. As a general rule of thumb if a pen fits in the non "S" holder you should use that one.

Only use the "S" holder if the pen is too big for the non "S" holder. This is especially

important on the Maker machine as the design prevents the common issue of pens rubbing

on the frame of the machine.

Thank you for purchasing the 3D Fun Printz Pen Holder

There are some tips below to get the best out of it.

FLEXING THEM BY HAND MAY BREAK THEM

a lot of heat.

ADJUSTMENT.