3D Fun Printz Cameo 4 Universal Pen Holder Instructions - Page 2
Parcourez en ligne ou téléchargez le pdf Instructions pour {nom_de_la_catégorie} 3D Fun Printz Cameo 4 Universal Pen Holder. 3D Fun Printz Cameo 4 Universal Pen Holder 4 pages.
Unscrew the top cap most of the way, but not all the way
Insert your pen so the nib just touches the recess inside the alignment clip as below. You
may need to wiggle the pen slightly to spread the flexible grips.
While gently holding the pen in place screw the top cap down so the flexible inserts retract
into the holder and grip the pen. The cap does not need to be screwed down hard, just
enough to grip the pen and stop it moving. Once the pen is held firmly continue to tighten
the cap until the flexible parts line up with the corners as shown below. This is important
for correct fitment into your machine.
The first few times you use the pen holder the cap may be slightly stiff but will ease with
use.
Now insert the holder into the machine.
DO NOT FORCE THE LATCH DOWN. IT SHOULD BE NO HARDER TO
LATCH THEN WITH ANY OTHER SILHOUTTE ACCESSORY. IF IT IS STIFF
REMOVE THE HOLDER, ADJUST AND REINSERT