3D Fun Printz Cameo 4 Universal Pen Holder 지침 - 페이지 2

{카테고리_이름} 3D Fun Printz Cameo 4 Universal Pen Holder에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Fun Printz Cameo 4 Universal Pen Holder 4 페이지.

Unscrew the top cap most of the way, but not all the way

Insert your pen so the nib just touches the recess inside the alignment clip as below. You

may need to wiggle the pen slightly to spread the flexible grips.

While gently holding the pen in place screw the top cap down so the flexible inserts retract

into the holder and grip the pen. The cap does not need to be screwed down hard, just

enough to grip the pen and stop it moving. Once the pen is held firmly continue to tighten

the cap until the flexible parts line up with the corners as shown below. This is important

for correct fitment into your machine.

The first few times you use the pen holder the cap may be slightly stiff but will ease with

use.

Now insert the holder into the machine.

DO NOT FORCE THE LATCH DOWN. IT SHOULD BE NO HARDER TO

LATCH THEN WITH ANY OTHER SILHOUTTE ACCESSORY. IF IT IS STIFF

REMOVE THE HOLDER, ADJUST AND REINSERT