3D Fun Printz Cameo 4 Universal Pen Holder 지침

{카테고리_이름} 3D Fun Printz Cameo 4 Universal Pen Holder에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Fun Printz Cameo 4 Universal Pen Holder 4 페이지.

Cameo 4 Universal Pen Holder Instructions

Thank you for purchasing the 3D Fun Printz Pen Holder

There are some tips below to get the best out of it.

Most importantly. The Pen Holder is partly made from PLA as it is a natural plastic

originating from corn starch and is recyclable. For these reasons it does not like heat.

Please don't leave it in the sun, on a hot windowsill, on or near a radiator or anywhere else

with a lot of heat.

Please also keep away from children and animals. PLA can be sharp when broken.

NEVER TRY AND ADJUST THE SCREW CAP WHILE THE HOLDER

IS IN YOUR MACHINE. YOU WILL DAMAGE YOUR MACHINE.

ALWAYS FULLY REMOVE THE HOLDER BEFORE ADJUSTMENT.

DO NOT FLEX THE TIPS BY HAND. THEY ARE DESIGNED TO

MOVE VERY SLIGHTLY TO ACCEPT A PEN NIB. FORCING A PEN

BODY ALL THE WAY THROUGH THE TIP OR FLEXING THEM BY

HAND MAY BREAK THEM

To fit a pen into the holder clip the alignment clip onto the holder as shown. It should

remain loosely in place without holding. There are tabs that fit into the holes on the pen

holder