Dish Network DuoDVR ViP 622 Configuration de la télécommande - Page 12
Parcourez en ligne ou téléchargez le pdf Configuration de la télécommande pour {nom_de_la_catégorie} Dish Network DuoDVR ViP 622. Dish Network DuoDVR ViP 622 17 pages. Receiver and remote controls
Également pour Dish Network DuoDVR ViP 622 : Manuel de l'utilisateur (17 pages)
Imprimer la page
222.book Page 68 Tuesday, July 25, 2006 1:30 PM
Chapter 9
The Recover Button
1
Turn on the other receiver and display the System Info screen as described in the user's
guide for information on how to display the screen).
Write the address:
2
Press and hold AUX until all the other mode buttons light up, and then let go of the button.
AUX flashes.
3
Press the 3 button.
4
Use the NUMBER PAD to enter the address you wrote in step 1.
5
Press POUND (#). AUX blinks three times.
6
Press RECORD to make sure the address in the remote matches the address on the
receiver.
T
R
HE
ECOVER
Use RECOVER if you suddenly have a snowy, blue, or black screen on your TV and
cannot get the picture back from your satellite receiver. When you press RECOVER as
described below, the remote control sends commands to your TV to change channels or
video inputs to get back to watching satellite programming. This procedure works only if
you have accidentally changed the TV channel or video input. It does not recover lost
satellite signal (See Troubleshooting on page 104 for information on solving problems).
Note: The remote must be programmed to control the TV (and VCR, if applicable) for
RECOVER to work as described.
Note: RECOVER will first try to tune your TV to channel 3, then channel 4, and then other
video inputs with each press of RECOVER. You may need to press RECOVER up to 30
times to recover your satellite TV video. If RECOVER is programmed to a specific channel
(see page 69), RECOVER will tune the TV to the specific channel (for example, channel
60).
68
B
UTTON