Abbyson Belmont Fire Table Manuel d'instructions de montage - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de montage pour {nom_de_la_catégorie} Abbyson Belmont Fire Table. Abbyson Belmont Fire Table 13 pages.

Imprimer la page

Operation (continued)

Lighting the fire pit

1. Push and slowly turn the control knob to the LOW position .

2. Hold ignitor to light the burner, release control knob after 5

seconds.

3. Observe the flame height when lit. Flame should be 3 to 13

inches high .

4. lf the burner does not light before the match goes out,

immediately turn the control knob to the OFF position.

5. Wait approximately five minutes to clear out any gas, and repeat

steps 1-4above.

6. If your burner fails to light again, turn the control knob to the OFF

position and contact your dealer or gas supplier.

Shut Down instructions:

o extinguish your gas burner, turn the control knob to the OFF

position. Be sure the control knob is turned fully off to avoid any gas

leakage.

NOTE: If burner fails to remain lit, close all

valves and wait 5 minutes before

attempting to light the fire pit again.

NOTE: When fire pit is on: The burner will

display blue and yellow flames. These

flames should not be yellow or produce

thick black smoke. This would indicate an

obstruction of airflow through the burners.

The flames should be blue with straight

yellow tops. If excessive yellow flames are

detected, turn off the burner and consult

"Troubleshooting" on page 13.

WARNING: Be careful when attempting to

manually ignite this fire pit. Improper

igniting procedure may cause injury or

property damage.