Abbyson Belmont Fire Table Manuel d'instructions de montage - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de montage pour {nom_de_la_catégorie} Abbyson Belmont Fire Table. Abbyson Belmont Fire Table 13 pages.

Imprimer la page

Operation

Connect and disconnect the LP Gas Tank

Connect: Open the door on the table base and place the

LP gas tank into the round tank holder.

Connect the regular to tank by turning the knob

clockwise until it stops.

Disconnect: Before disconnecting make sure the LP gas

tank value is "CLOSED".

Disconnect regular from LP gas tank by turning knob

counterclockwise until it is loose.

Open the drawer and place the 20 pound gas tank on the

tank support .

Secure the tank on the bottom base by screw ,and

using the strap (D) to fix the tank to prevent the tank

from moving . Attach the tank strap to the hook on the

drawer panel .

Attach the fire bowl to the gas tank with the hose from the

fire bowl.

Close the drawer.

Mix two to three ounces of a soapy solution to check for

leaks. Use one part liquid dishwashing detergent and

three parts water.

Apply several drops of solution where the hose attaches

to the regulator.

Apply several drops of solution where the regulator

connects to the cylinder.

Make sure all fire pit and ignition valves are off.

Turn the cylinder valve on.

If any soap bubbles are visible where the solution has

been applied, the connections must be tightened

another turn and the leak check must be performed

again.

WARNING: Follow all leak-checking procedures

before operating. To prevent fire or explosion

hazard when testing for a leak:

•

Always perform a leak test before lighting the

outdoor fire pit table and each time the tank is

connected for use.

•

No smoking. Do not use or permit any possible

sources of ignition in the area while conducting

a leak test.

•

Conduct the leak test outdoors in a well-

ventilated area.

•

Do not use matches, lighters, or a flame to

check for leaks.

•

Do not use the outdoor fire pit table until any

and all leaks are corrected.

If you are unable to stop a leak, disconnect the LP

gas supply. Call a gas appliance serviceman or your

local LP gas company.

NOTE: If burner fails to remain lit, close all

valves and wait 5 minutes before attempting to

light the fire pit again.

NOTE: To operate, you will need a standard 20

pound propane tank.