3D Upfitters AnkerMake M5 Manuel d'installation - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} 3D Upfitters AnkerMake M5. 3D Upfitters AnkerMake M5 18 pages.

Imprimer la page

If you forget to turn on the fan when printing PLA, your printer will probably clog.

If that happens, use a 3D printer needle (available in many places online) to remove the

clog. This technique is easy and works most of the time.

It is acceptable to turn oﬀ the fan when printing ABS or ASA to bring the temperature

into the ideal range, but be sure to turn the fan back on when you're ﬁnished,

especially if you are venting or ﬁltering the air to remove VOCs.

7. Tighten Gaps

Once the enclosure is completely put together, it is time to ensure that each panel is

held tightly to each adjoining panel. The connectors are designed with a small amount

of play, allowing you to make minor adjustments for the perfect ﬁt.

1. Loosen screws on the panel to move.

2. Push that panel into place. You may need a friend to hold it tightly in the right spot.

3. Re-tighten the screws to hold the panel. Only tighten enough to hold the pieces

snuggly. DO NOT OVER-TIGHTEN! These parts are sturdy, but they're still all made of

plastic.

Repeat the process, going around the enclosure to ensure all panels are ﬂush.

8. Assemble Spool Holder

The ﬁlament feeds into the extruder through the gaps in the side doors. You can

place the spool holder on the table besides the printer or on top of the enclosure.

Slide the AnkerMake M5's aluminum spool holder into the slot, then use the 4 M4

screws to attach it to the base securely. Note that there are two lengths of screws; the

shorter screws got on top, and the 2 longer screws are on the bottom.