CAME BK-2200T Manuel d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} CAME BK-2200T. CAME BK-2200T 17 pages.

1 – Gearmotor

2 – ZTC/ZT6C control panel

3- Limit-switch tabs

4- Rack

5- Key-operated selector switch

Motor to base anchorage

The following applications are only examples, as the space required for unit installation and the accessories vary depending on

dimensions and therefore it is up to the installer to select the best solution.

Install the screws in the anchor plate and fasten them with a nut, then bend the preformed clamps downwards.

Construct a cement foundation that is large enough to accomodate the gear motor (it is a good idea to protrude 50 mm. from the

ground). When pouring the foundation, embed the gear motor anchor plate and the relative clamps in the cement.

The anchor bolts should be embedded in the concrete in the positions indicated; the drive unit is then attached to this bots. The anchor

plate must be perfectly level and absolutly clean; the bolts threads must be completly exposed.

N.B.: The ﬂ exible tubes for the electrical wiring must be embedded in the base and protude in the correct position.

Fixing plate / Anchor stays

6- Flashing light indicating door movement

7- Antenna

8- Safety photocells

9- Photocell column

10- Closure stop

11- Sensitive edge

Rack-limit

Cables

C A

M E

Gate wing

Struttura ﬁ ssa

Concrete

base