Clearmount SW7 Instructions d'assemblage - Page 6

Parcourez en ligne ou téléchargez le pdf Instructions d'assemblage pour {nom_de_la_catégorie} Clearmount SW7. Clearmount SW7 6 pages. Miter saw scale

Imprimer la page
S S E E C C U U R R I I N N G G Y Y O O U U R R S S Y Y S S T T E E M M T T O O W W O O R R K K S S U U R R F F A A C C E E & & A A T T T T A A C C H H I I N N G G S S T T O O P P & & C C L L A A M M P P S S : :
• Secure your Miter Saw System to a suitable work surface (bench or stand) by following instructions in
your saw manual.
• Attaching Stop - Place the slot in the stop over the fence with the red handle to the rear of scale. Pull
the handle upright to lock / Push it back to unlock
** Some saws, because of the design of their fence, restrict how closely to the saw you can put the stop.
If this occurs with your saw, take a piece of moulding, mitered on both ends, and place it between the
moulding to be cut and the stop, which can now be located farther away from the saw. For example, if
you use a 10" piece of moulding as a spacer and you want to cut a 5" piece, set the stop at 15".
• Attaching Clamps - Loosen 2 wing nuts on each clamp. Place the square heads of bolts in the horizon-
tal channel that runs along the entire front of the scale base. Screw one of red tipped pins into the
clamp (different sizes and different depths for various moulding widths). Position the clamp towards
the saw. Lifting the red handle of the clamp moves the pin to push your moulding against the fence of
the scale. Repeat for the 2nd clamp.
Metal moulding always requires clamping - Metal moulding must come in contact with both fences,
otherwise it is too short and you are at risk being hurt by flying pieces of moulding! Also, improve
the quality of your cut and prolong the lift of your blade by using a lubricant when cutting metal.
page 6
C
LAMP
A
DJUSTABLE
P
IN
CHANNEL ON BASE
S
TOP