Clearmount SW7 조립 지침 - 페이지 6

{카테고리_이름} Clearmount SW7에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clearmount SW7 6 페이지. Miter saw scale

S S E E C C U U R R I I N N G G Y Y O O U U R R S S Y Y S S T T E E M M T T O O W W O O R R K K S S U U R R F F A A C C E E & & A A T T T T A A C C H H I I N N G G S S T T O O P P & & C C L L A A M M P P S S : :

• Secure your Miter Saw System to a suitable work surface (bench or stand) by following instructions in

your saw manual.

• Attaching Stop - Place the slot in the stop over the fence with the red handle to the rear of scale. Pull

the handle upright to lock / Push it back to unlock

** Some saws, because of the design of their fence, restrict how closely to the saw you can put the stop.

If this occurs with your saw, take a piece of moulding, mitered on both ends, and place it between the

moulding to be cut and the stop, which can now be located farther away from the saw. For example, if

you use a 10" piece of moulding as a spacer and you want to cut a 5" piece, set the stop at 15".

• Attaching Clamps - Loosen 2 wing nuts on each clamp. Place the square heads of bolts in the horizon-

tal channel that runs along the entire front of the scale base. Screw one of red tipped pins into the

clamp (different sizes and different depths for various moulding widths). Position the clamp towards

the saw. Lifting the red handle of the clamp moves the pin to push your moulding against the fence of

the scale. Repeat for the 2nd clamp.

Metal moulding always requires clamping - Metal moulding must come in contact with both fences,

otherwise it is too short and you are at risk being hurt by flying pieces of moulding! Also, improve

the quality of your cut and prolong the lift of your blade by using a lubricant when cutting metal.

page 6

LAMP

DJUSTABLE

CHANNEL ON BASE

TOP