Alto-Shaam 1000-MR1 Manuel d'utilisation et d'entretien - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Alto-Shaam 1000-MR1. Alto-Shaam 1000-MR1 14 pages. Mobile refrigerated cart
Également pour Alto-Shaam 1000-MR1 : Fiche technique (2 pages), Installation Fonctionnement et entretien (17 pages)

Imprimer la page

6.6 DOOR HANDLE REPLACEMENT

NOTE:

It may be necessary to remove the

handle assembly in order to get the

cabinet through a door opening.

1. Remove the three side mounting screws in latch.

2. Remove two screws in strike.

3. Replace in reverse order.

6.7 DOOR GASKET REPLACEMENT

NOTE:

It is suggested that the door be

removed from the cabinet and placed

face down on a work table.

1. Remove the fasteners and pull old gasket

from the retainer.

2. Clean gasket retainer and immediate area.

3. Start new gasket into retainer. After gasket

is positioned, replace fasteners.

NOTE: Avoid cutting the gasket if possible.

6.8 DOOR HINGE REPLACEMENT

This procedure will require two people.

NOTE:

One person to hold the door while the

other removes the attachment screws.

S C H E D U L E D M A I N T E N A N C E

6.8 POWER SWITCH REPLACEMENT

SWITCH THE CONTROL PANEL POWER

TO THE "OFF" POSITION AND

DISCONNECT THE POWER SUPPLY

CORD BEFORE SERVICING.

Operation and Care Manual #8410/11 • 5

1. Using a screwdriver, remove the three screws

which attach the butt section of the hinges to

the cabinet.

2. With the door detached from the cabinet,

remove the screws which attach the second

part of the hinge to the door.

3. To install the replacement hinge, reverse the

process.

1. Disconnect the unit from the power source.

2. Remove the silicone seal around the

perimeter of the front control leader panel.

Remove the panel by lifting straight up.

3. Using a flat blade screwdriver, remove the

cover plate with switch attached.

4. Remove the wires connected to the switch.

5. Unscrew the lock washer and remove the

switch.

6. Reverse the process to install the new

switch.

7. Remount panel and reseal with silicone.