CLEARSONIC IsoPac Instructions de montage - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} CLEARSONIC IsoPac. CLEARSONIC IsoPac 2 pages.

3. Now you and your assistant are ready to move the CSP panel system into place. Use

soft gloves if you have them to avoid fingerprints. Close the system up and walk it to

the center front of the kit. Rough position the panels by opening in both directions and

wrapping around the both sides of the kit. For small adjustments and final placement, we

recommend that you and your assistant get down on your knees and use the cable pass

openings at the bottom of the system for grips to shift the panels left, right, in, or out. The

system will seem a bit unstable until the Lid is dropped on top.

4. Measure the distance between the end panels and extend the telescoping support bar to

the same length. Place the bar end "J" hooks onto top of the end panels of your ClearSonic

Panel system about 5 inches from the back edge. This bar will support the Lid panels in

the back and the front of the CSP system will hold the lid panels in front. Place the

rectangular STC5 Lid section on top towards the center so that the SORBER overhangs

the front panel by an inch or two. The trapezoid-shaped STS5 units go on either side of the

center STC5. We recommend that you leave at least some gaps for air to be introduced. It

could get very hot inside the booth without some air exchange. The fan will help facilitate

the air exchange.

5. Depending on the IsoPac you have, place the free-standing SORBER S5-2, S4-2, or

A5-5 units behind the kit. Place the Velcro pieces on the S1 and S2 units to be stuck to

the CSP. The bottom row of S2 units that are resting on the floor only need Velcro on the

top edges. On the SORBER units placed higher up, we recommend using at least four

Velcro pieces. Place the Velcro about an inch from the side edge and on the top and

bottom edges of the baffles. Peel the paper off the Velcro just before placing the baffle in

the desired location. Have your assistant apply opposing pressure on the outside of the

CSP and press the S1 or S2 firmly to bond Velcro to the CSP. The free-standing models

can be tacked together using the 4" Velcro flaps provided at the top and bottom edge of

each SORBER panel to create a continuous SORBER wall.

6. The quiet 2-speed fan simply clips onto the top of the back S5-2 or STC5.

Please feel free to call us at 330-650-1420 with any questions or comments you might

have and thank you for using ClearSonic products!

Page 2