Altox WBUS-5 Manuel opérationnel

Parcourez en ligne ou téléchargez le pdf Manuel opérationnel pour {nom_de_la_catégorie} Altox WBUS-5. Altox WBUS-5 4 pages.

General Guide for Installation

- Install the device as far as possible from metal parts and wiring

Altox

harnesses.

- Recommendation: connect device supply directly to the OBD-II connector

wires where pin 16 is +12В, pin 4 is GND (common).

- Analog output AN commutates at +12V. It is used to start some heaters

using an analogous signal and to connect status LED located in the button

from the package.

- Auxiliary output OUT commutates at GND. It is used to connect a coolant

pump or the interior's heater via a power relay. It is switched on with the

delay (TIME2 setting) and/or based on the coolant temperature (LTEMP1

setting) after the heater is switched on. It is switched off with the delay

(parameter TIME3) after the heater is switched off.

- If there are other control units on the bus, it is recommended to connect

the module's control wire (blue) via normally open signaling relay

controlled by output OUT.

In this case you should activate setting SEPARLINE1 that activates this relay

before the data exchange.

O p e r a t i o n a l M a n u a l

- In some vehicles heater's power supply might be switched off when the

car is not moving. In this case you might need to "wake" it up by sending a

pulse signal. You should switch output OUT to impulse mode and set pulse

duration using setting PULSEOUT. The output is activated only when the

ALTOX WBUS-5

heater starts.

-If you need to implement additional options of remote control of output

OUT (for example, to block engine remotely) activate setting SEPAROUT1.

It switches the output mode into manual control mode (SMS-commands:

ACTIVATE / DEACTIVATE).

In this mode setting KEEPOUT1 activates option to save and to

subsequently restore of output OUT state when the module's power supply

is switched off and then switched on, respectively.

Please indicate the place of ALTOX module's location in the vehicle for

possible maintenance:

Authorized Service:

Installation Date: