AIMS PWRINV800W Manuel du propriétaire - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} AIMS PWRINV800W. AIMS PWRINV800W 6 pages. 800 watt power inverter

Imprimer la page

Source of Power

Most automobile and marine batteries will provide an ample power supply to

the inverter for 30 to 60 minutes even when the engine is turned off. Actual

time may vary depending on the age and condition of the battery and the power

demand being placed on it by the equipment being operated.

If you decide to use the inverter while the engine is off, we recommend that you

start the engine every 30 to 60 minutes and let it run for approximately 10

minutes to recharge the battery. It is also recommended that the device

plugged into the inverter be turned OFF before starting the vehicle engine.

Although it is not necessary to disconnect the inverter when starting the vehicle

engine, it may momentarily cease to operate as the battery voltage decreases.

When the inverter is not supplying power, it draws very low amperage from the

battery. It is recommend that the inverter always be disconnected when not in

use.

Blown Inverter Fuses

Your power inverter is equipped with 35-amp spade type fuses. With

reasonable care, it should not be necessary to replace

In general, most blown fuses are the result of reverse polarity hook up of the

inverter to a 12-volt power source (positive to negative and/or negative to

positive). If the fuse happens to blow, disconnect the appliance or equipment

from the inverter immediately. Find the source of the problem and repair it, and

then install a new fuse of the same type and size.

Note: Always disconnect the power inverter from the 12-volt power source and

make sure the inverter is turned OFF before replacing the fuse.

Safety and Usage Precautions

• For best operating results, place the inverter on a flat surface

• Keep inverter dry. Do not expose inverter to rain or moisture.

• DO NOT operate the inverter if you, the inverter, the device being operated, or

any surface that may come into contact with the inverter are wet. Water and

other liquids can conduct electricity, which may lead to serious injury or death.

• Avoid placing the inverter on or near heating vents, radiators or other sources

of heat. Do not place or use the inverter in direct sunlight. Ideal air

temperatures should be between 50° and 80° F .

• In order to properly disperse the heat generated from the inverter while it is

operating, keep the inverter well ventilated. Keep the area surrounding the

inverter clear while in use.

• Do not use the inverter near flammable materials. Do not place the inverter in

areas such as battery compartments where fumes or gases may accumulate.

Power Inverter 800W

these.

Inverter Protection Features

• Short Circuit Protection. The inverter will automatically shut down until

short is removed.

• Low Voltage Alarm. An alarm will sound when the voltage from the battery

discharges to 10.5 +/- 0.5 volts DC. This is an indication that the battery needs

to be recharged.

• Over Voltage Protection. The RED LED Indicator Light will illuminate and

the inverter will automatically turn itself off when the input exceeds 16.5 +/- 1

volt DC.

• Under Voltage Protection. The RED LED Indicator Light will illuminate

and the inverter will automatically turn itself off when the input is less than

10.0 +/- 0.5 volts DC.

• Overload Protection. The RED LED Indicator Light will illuminate and the

inverter will automatically turn itself off when the continuous draw of the

equipment being operated exceeds 800 watts or the surge draw of the

equipment exceeds 1600 watts.

• Thermal Protection. The RED LED Indicator Light will illuminate and the

inverter will automatically turn itself off when the circuit temperature exceeds

130° F .

Notes

• The inverter is equipped with a cooling fan, which is designed to run

automatically when the inverter

caused by high circuit temperatures will occur when the cooling fan

the unit

is unable

to maintain a cool enough temperature for safe operation.

• In the event of automatic shut down or a continuous audible alarm, turn the

inverter power switch to the OFF(O) position until the source of the problem

has been determined and resolved.

Television and Audio Suggestions

Although all AIMS Power inverters are shielded and filtered to minimize signal

interference, some interference with your television picture may be unavoid-

able, especially with weak signals. However, here are some

suggestions that may improve reception:

• Make sure the television antenna produces a clear signal under normal

operating conditions (at home plugged into a standard 110/120-volt AC outlet).

Also, ensure that the antenna cable is properly shielded and/or good quality.

• Change the positions of the inverter, antenna cables and the television power

cord.

• Isolate the television, its power cord and antenna cables from the 12-volt

power source by running an extension cord from the inverter to the television

set.

Owner's Manual

to get hot.Automatic shut down of

begins