- ページ 4

インバーター AIMS PWRINV800WのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。AIMS PWRINV800W 6 ページ。 800 watt power inverter

AIMS PWRINV800W オーナーズマニュアル
Source of Power
Most automobile and marine batteries will provide an ample power supply to
the inverter for 30 to 60 minutes even when the engine is turned off. Actual
time may vary depending on the age and condition of the battery and the power
demand being placed on it by the equipment being operated.
If you decide to use the inverter while the engine is off, we recommend that you
start the engine every 30 to 60 minutes and let it run for approximately 10
minutes to recharge the battery. It is also recommended that the device
plugged into the inverter be turned OFF before starting the vehicle engine.
Although it is not necessary to disconnect the inverter when starting the vehicle
engine, it may momentarily cease to operate as the battery voltage decreases.
When the inverter is not supplying power, it draws very low amperage from the
battery. It is recommend that the inverter always be disconnected when not in
use.
Blown Inverter Fuses
Your power inverter is equipped with 35-amp spade type fuses. With
reasonable care, it should not be necessary to replace
In general, most blown fuses are the result of reverse polarity hook up of the
inverter to a 12-volt power source (positive to negative and/or negative to
positive). If the fuse happens to blow, disconnect the appliance or equipment
from the inverter immediately. Find the source of the problem and repair it, and
then install a new fuse of the same type and size.
Note: Always disconnect the power inverter from the 12-volt power source and
make sure the inverter is turned OFF before replacing the fuse.
Safety and Usage Precautions
• For best operating results, place the inverter on a flat surface
• Keep inverter dry. Do not expose inverter to rain or moisture.
• DO NOT operate the inverter if you, the inverter, the device being operated, or
any surface that may come into contact with the inverter are wet. Water and
other liquids can conduct electricity, which may lead to serious injury or death.
• Avoid placing the inverter on or near heating vents, radiators or other sources
of heat. Do not place or use the inverter in direct sunlight. Ideal air
temperatures should be between 50° and 80° F .
• In order to properly disperse the heat generated from the inverter while it is
operating, keep the inverter well ventilated. Keep the area surrounding the
inverter clear while in use.
• Do not use the inverter near flammable materials. Do not place the inverter in
areas such as battery compartments where fumes or gases may accumulate.
Power Inverter 800W
these.
5
Inverter Protection Features
• Short Circuit Protection. The inverter will automatically shut down until
short is removed.
• Low Voltage Alarm. An alarm will sound when the voltage from the battery
discharges to 10.5 +/- 0.5 volts DC. This is an indication that the battery needs
to be recharged.
• Over Voltage Protection. The RED LED Indicator Light will illuminate and
the inverter will automatically turn itself off when the input exceeds 16.5 +/- 1
volt DC.
• Under Voltage Protection. The RED LED Indicator Light will illuminate
and the inverter will automatically turn itself off when the input is less than
10.0 +/- 0.5 volts DC.
• Overload Protection. The RED LED Indicator Light will illuminate and the
inverter will automatically turn itself off when the continuous draw of the
equipment being operated exceeds 800 watts or the surge draw of the
equipment exceeds 1600 watts.
• Thermal Protection. The RED LED Indicator Light will illuminate and the
inverter will automatically turn itself off when the circuit temperature exceeds
130° F .
Notes
• The inverter is equipped with a cooling fan, which is designed to run
automatically when the inverter
caused by high circuit temperatures will occur when the cooling fan
the unit
is unable
to maintain a cool enough temperature for safe operation.
• In the event of automatic shut down or a continuous audible alarm, turn the
inverter power switch to the OFF(O) position until the source of the problem
has been determined and resolved.
Television and Audio Suggestions
Although all AIMS Power inverters are shielded and filtered to minimize signal
interference, some interference with your television picture may be unavoid-
able, especially with weak signals. However, here are some
suggestions that may improve reception:
• Make sure the television antenna produces a clear signal under normal
operating conditions (at home plugged into a standard 110/120-volt AC outlet).
Also, ensure that the antenna cable is properly shielded and/or good quality.
• Change the positions of the inverter, antenna cables and the television power
cord.
• Isolate the television, its power cord and antenna cables from the 12-volt
power source by running an extension cord from the inverter to the television
set.
Owner's Manual
to get hot.Automatic shut down of
begins
6