Altrad BELLE COMPACT 350X Manuel de l'opérateur - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Altrad BELLE COMPACT 350X. Altrad BELLE COMPACT 350X 15 pages.
Imprimer la page
Safe Disposal.
Instructions for the protection of the environment. The
machine contains valuable materials. Take the discarded
apparatus and accessories to the relevant recycling
facilities.
Pre start-up inspection.
The following Pre-start-up inspection must be performed before the start of each work session or after every four hours of use, which-
ever is rst. Please refer to the service section for detailed guidance. If any fault is discovered, the oor saw must not be used until the
fault is recti ed.
1. Thoroughly inspect the oor saw for signs of damage. Check components are present and secure. Pay special attention to the
blade safety guard.
2. Check uid lines, hoses ller openings, drain plugs and any other areas for signs of leakage. Fix any leaks before operating.
3. Check the engine oil level and top up as necessary.
4. Check the engine fuel level and top up as necessary.
5. Check for fuel and oil leaks.
CAUTION
Honda GX390 Petrol Engine
1.
Ensure that the blade is fully raised in the guard by means of the foot pedal.
2.
Open the fuel tap by moving the fuel ON / OFF lever fully to the right.
3.
If starting the engine from cold, set the choke ON by moving the choke lever
fully to the left. If restarting a warm engine, the choke is usually not required,
However, if the engine has cooled to a degree, partial choke may be required.
4.
Turn the engine ON / OFF switch clockwise to the 'I' position.
5.
Set the throttle to the idle position by moving the throttle lever fully to the right.
6.
Taking a rm hold of the control handle with one hand, grasp the recoil starter
handle with the other. Pull the recoil starter until engine resistance is felt, then let
starter return.
7.
Taking care not to pull the starter's rope fully out and pull the starter handle
briskly.
8.
Repeat until the engine res.
9.
Once the engine res gradually set the choke lever to the OFF Position by moving it to the right.
10. If the engine fails to re after several attempts, follow the trouble-shooting guide.
11. To stop the engine, fully raise the blade into the guard and set the throttle to idle. Allow the engine to idle for at least 2 minutes
12. Turn the engine ON / OFF switch anti-clockwise to the '0' position.
13. Turn the fuel off.
Pre-Start Checks
Start & Stop Procedure
Improper maintenance can be hazardous. Read and Understand this section before you perform any
maintenance, service or repairs.
Environment
Component
Hand Grips
Main Frame
Petrol Engine
Various Parts
11
Handle
GB
Material
Steel
Rubber
Steel
Aluminium
Steel and Aluminium
GB
GB
Throttle Lever
Choke Lever
Fuel ON/OFF
Lever.