Altrad BELLE COMPACT 350X Manuel de l'opérateur - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Altrad BELLE COMPACT 350X. Altrad BELLE COMPACT 350X 15 pages.
Imprimer la page
GB
•
Take the oor saw to where it is required.
If the oor saw is to be transported to another location, ensure that the blade is fully raised in the guard and that the engine has
been switched off. NEVER transport the oor saw with the blade lowered or with the engine still running, even if it is only being
moved a short distance.
Check that the water outlet valve is closed, then ll the water bottle with clean water. To ensure a steady stream of water, always
make sure that the water bottle water level is kept constant.
If a Bowser is used, ensure that the water outlet valve is closed before connecting the supply to the saw. Once ceonnected, use the
valve to control the ow of water and to ensure a steady stream of water to the blade.
•
Having carried out the checks listed in the 'pre start' section, you may start the engine.
The blade should now be spinning at idle speed. ALWAYS check the blade for any signs of wobble, vibration or unusual noise. If
any of these occur, stop the machine immediately and refer to the troubleshooting section.
•
Set the throttle to maximum, use the control lever to gently lower the blade into the cut and use the depth marker to
achieve the required depth of cut.
The saw will then require gentle forward movement to achieve the cut.
The speed of travel will be determined by the condition of the surface being cut.
DO NOT stand in line with the blade and the stream of hot particles whilst sawing.
NEVER plunge the blade harshly into the cut.
If the surface to be cut is very hard, the saw will take longer to cut. Try to make more than one pass as this will reduce otherwise
excessive wear of the blade.
DO NOT try to force the saw forwards as this will cause damage to the blade.
DO NOT try to cut curves as this will cause stress cracks or fragmentation of the blade.
•
To stop the oor saw, follow the Start / Stop Procedure.
Operating Instructions
12