ClearWater ELEGANCE EL20 Instructions de montage et liste des pièces - Page 3

Parcourez en ligne ou téléchargez le pdf Instructions de montage et liste des pièces pour {nom_de_la_catégorie} ClearWater ELEGANCE EL20. ClearWater ELEGANCE EL20 3 pages.

Figure 1
Figure 3
Figure 5
Replace the aerator
Figure 2
Figure 4
Before installation, please confirm whether the flexible hose (ster0033) is tightened, and
tighten it completely by hand. (Figure 1)
Pass the flexible hoses and threaded stud through the sink top from above and place the
mixer in position on the sink. (Figure 2)
(Make sure that sealing washer has been fitted to the mixer body.)
Slide the flat washer and fixing nut up the flexible hoses, and then screw the nut all the way
up making sure the tap is in the correct position. (Figure 3)
(Note:The thickness of sink>35mm no need to use the mounting seat.)
Connect the Check valve marked Ster0107 to the cold tail.(Figure 4)
Having first checked all new connections, turn on the mains stop cock, close all taps
except the new mixer and as the system starts to refill check for leaks.
If you feel that the flow rate is too low during use, you can unscrew the upper section of the
smart aerator (Ster0226) counterclockwise to remove the smart aerator and replace the
regular aerator (Ster0225). (Figure 5)