Altron AL-761-N Manuel d'instruction - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Altron AL-761-N. Altron AL-761-N 19 pages.

● HOW TO REMOVE AIR FROM THE WATERWAY:

It is necessary to perform the air drawing step for the following situations:

○ Initial use

○ Error indication E – 2

○ Air was mixed in to electrolysis agent supply tube

○ Electrolysis agent tank went to empty and new agent supplied

Air drawing of pump.

Turn the diverter lever horizontal and then turn the water on.

Power on and check the display panel indicating processing value.

Open the operation panel and press air draw button.

＊ Air drawing lamp will come on and the air drawing operation will start.

＊ Air drawing operation takes around 6 minutes to complete.

＊ If the process is interrupted, press the air draw button again.

＊ No operational button will work during the air drawing process.

Air drawing operation will stop

automatically after the air drawing

process is finished.

＊ Water will run out from outlet

position for a maximum of 40

seconds before the drain

operation finishes.

＊ Water will stop after the air drawing

operation and the air draw lamp

will shut off..

＊ While air drawing, the outlet water

should not be used for any

purpose.

＊ If the E-2 indicator comes on, an

empty electrolysis agent liquid

condition may exist and terminating the

air drawing process.

When the error condition E2 is indicated, please follow the steps below:

①

②

Is there an adequate amount of Electrolysis agent?

Check the tube connection between electrolysis agent tank and the