dji Phantom FC40 Manuel de démarrage - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} dji Phantom FC40. dji Phantom FC40 11 pages.

DJI Phantom 1 & FC40 setup – Getting Started Guide

Here is a basic compass calibration video:

Time to ﬂy!

MAKE SURE YOUR S1 AND S2 SWITCHES ARE BOTH IN THE UP POSITIONS.

Move both the Rt and Lft joysticks down and towards the inside or outside corners of the TX.

This will start your Phantom's motors and they will idle at a low RPM. Now, move your left

joystick all the way up to full throttle. Your FC40 should take oﬀ. Let go of the joystick (it will

return to center automatically) once it's about 10-15 feet up. Let it hover a bit. Use your right

joystick and move slightly left, right,forward and back. Just a little at a time, testing the

movement and response.

Practice makes perfect, so spend some time getting the hang of how the FC40 reacts to your

stick movements.

Landing

Bring your Phantom down toward the ground by pulling down on the left stick (throttle)-

making sure you slow the rate of descent when you get within 5 feet of the landing area.

Then use small movements of the stick to slowly make it touch down. Then turn the motors

oﬀ.

There are two ways to turn your motors oﬀ. These are the same moves used to start the

motors and are described in the manual. It will help to practice turning the motors oﬀ and on

before you ﬂy – that is, turn them on to idle position and then turn them oﬀ. This will make

certain you don't panic or over-react when you actually start real landings.

ALWAY DISCONNECT THE PHANTOM BATTERY BEFORE TURNING OFF THE TX. Turning oﬀ the