dji Phantom FC40 Manuel de démarrage - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} dji Phantom FC40. dji Phantom FC40 11 pages.

DJI Phantom 1 & FC40 setup – Getting Started Guide

Naza Asst.

Open the NAZA assistant and check for and install any suggested Phantom ﬁrmware updates.

Under the "Advanced" tab, choose the "IOC" tab and activate it.

Under "F/S" (failsafe), make sure it is set to "Go-Home and Landing"

Under "Limits", set them at something reasonable. 2000 yards is useless. You can use these

to keep it close to you while you learn. Something like 100 meters would be better at ﬁrst.

Under the "Basic" tab, click on "R/C". At the bottom you will see a horizontal line. At the right

end of it is an arrow that will bringup a pull down menu. Change it to "Failsafe"

You have to hit the return button on your computer to save some of the changes. You can

always double check by quitting the NAZA assistant and opening it again and then seeing

whether the Assistant software has the new settings.

Now when you put the right hand switch(S1) to the bottom, it will activate the"Return to

Home, Fail Safe" function. Now you will notice that when you move the S2 (left side) switch

down on your remote, the corresponding action will appear in the Naza Assistant.

When you set the left hand switch(S2) to the bottom (Home Lock), the quad will ﬂy the

direction you move the right stick, regardless of which way it is facing. Some people call this

"headless mode" . When in the middle position you will be in Control lock, which corresponds

to the remotes position, and the FC40s compass position. These modes can be confusing so

be sure to watch a video which explains them. Most pilots only use the Home Lock – it's

handy when you lose orientation and want to bring the Phantom back closer to your position.