Artison RCC600-SM Manuel d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Artison RCC600-SM. Artison RCC600-SM 13 pages. Subwoofer module | freestanding subwoofer | subwoofer amplifier | cabinet mount
Également pour Artison RCC600-SM : Manuel d'installation (19 pages)

Imprimer la page

properly so that it does not interfere with the driver's operation. The design of

the IW PBB is such that there is NO clearance between the back of the

subwoofer module and the back of the PBB. Be careful that no wires are in this

area when installing the module

1. Use the provided Cut-out Template to mark the desired wall location. Be sure that no piping,

wall studs, or electrical wires interfere with the placement of the RCC600-SM.

2. Once the hole is cut and the speaker wire is run, manage both the positive and negative

speaker wire conductors through the open tie-wraps on each side of the RCC600-SM.

3. Connect the bare speaker wire ends to the spring-loaded binding posts, manage the speaker

wire back, tighten the tie-wraps and trim the excess.

4. Install the RCC600-SM into the pre-cut opening of the Pre-Build Box. See Figure 1.

5. Carefully tighten the six dog leg clamps on the RCC600-SM using

wrench.

6. The grille for the RCC600-SM is held in place by magnets. Simply position the grille on the

front of the module into the recessed area. See Figure 2.

7. Remove the paint-shield from the front of the RCC600-SM after the installation has been

completed

NOTE: While installing the subwoofer module ensure any excess wire is run properly

so it does not interfere with the driver's operation.

INSTALLATION INTO AN INFINITE BAFFLE

the supplied Allen Head