Alula RE118 Manuel d'installation

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Alula RE118. Alula RE118 2 pages. Flood & temp sensor interlogix compatible

Imprimer la page

Resolution Compatibles

Flood and Temp Sensor

It detects flood conditions and reports extreme temperatures.

Features

• Titanium probes for unmatched corrosion immunity

• IP67 rated waterproof enclosure

• GORE

vent to prevent seal failure

• 5 year warranty

Enroll

the flood zone by placing the panel into wireless

enrollment mode and removing the battery tabs or tampering

the sensor. The freeze and heat zones are disabled by default.

To activate and enroll the freeze and heat zones, remove the

sensor cover and use a wire or paper clip to short the desired

outer terminal to the center terminal. To maximize battery life,

only activate the zones being used.

DL ID Configuration

• Flood ID is the serial number shown on the device.

• Freeze ID is the serial number with last digit

replaced with a 1.

• Heat ID is the serial number with last digit replaced

with a 2.

Install

by placing the sensor in the location requiring flood or

temperature detection. If desired, the wall clip can be used to

secure the sensor.

Optional Screw Mounting

• Remove the wall clip from the sensor's body.

• Secure the clip to a wall, baseboard or cupboard

using a #6 screw.

• Slide the sensor's body down onto the wall clip until

it snaps into place.

Detects

water pooled under the sensor and reports extreme

temperature conditions.

Temperature Trip Points

• Heat alarms when over 100°F (38°C)

• Heat restores when under 97°F (36°C)

• Freeze alarms when under 45°F (7°C)

• Freeze restores when over 48°F (9°C)

To replace the batteries,

the front slot and twist. Slide both old batteries out and the

new batteries in. To reinstall the cover, align the rear latches

and roll the cover forward until it snaps into place.

Verify proper enrollment and operation using your control panel's installation manual.

RE118 Flood & Temp Sensor

Interlogix

is an integrated environmental sensor.

insert a flat blade screwdriver into

Compatible

Wall Clip

Mounting Screw Hole

Front slot