Alumax ProLine PL70 Manuel d'instructions d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Alumax ProLine PL70. Alumax ProLine PL70 8 pages. Heavy frameless bypass bath enclosure

Imprimer la page

Fixed Panel Installation - Install the "peel-and-stick" Wall Seal [EE]

on the wall side edge of the Fixed Panel. Orient it with the open

end to the inside of the enclosure. Lift the Fixed Panel and set it in the

Glass Clips with the edge as tight to the wall as possible. Loosen the

Set Screws in the Wall Mount Sleeves and slide them over the Wall

Mount Blocks. Snug the Set Screws into the block (DO NOT TIGHTEN).

Loosen, but do not remove, the Glass Mount Screws and make sure the

Header Bar is still level, or has a slight tilt toward the door side. Small

adjustments in the Header Bar can be made with the Set Screws in the

Wall Mount Sleeves. Once you have the Header Bar set as you want

it, and the Fixed Panel positioned correctly, tighten the Wall Mount Set

Screws, then the Glass Mount Screws.

Door Panel Installation – Lift the Door Glass [P] and place the

rollers on the bar, making sure to get the bottom edge of the Door

Glass into the Center Guide. To adjust the Rollers, up or down, use the

adjustable wrench to loosen the roller and use a 5/32" Allen wrench to

turn the adjuster on the roller mounting plate. Turning the hole in the

adjuster plate to the down position will lower the glass, turning it to the

up position will raise the glass. CAUTION: DO NOT LET THE GLASS

FALL. Install the Anti-Jump by placing an Anti-Jump Plastic Washer

[FF] and the Anti-Jump Glass Insert [GG] over the Anti-Jump Main Shaft

[HH]. Insert through the hole in the door glass, below the bar from the

inside with the threaded end of the shaft pointing to the outside. Place

another Anti-Jump Plastic Washer, an Anti-Jump Spacer [I I], and thread

the Anti-jump End Cap [JJ] and Anti-Jump Sleeve [KK] onto the main

shaft. Adjust so that the Anti-Jump Sleeve and End Cap are as close to

the bottom of the bar as possible and tighten. Install the other Anti-Jump

assembly.

Page 8 of 9