Alumax ProLine PL70 Інструкція з монтажу Посібник з монтажу - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Корпус Alumax ProLine PL70. Alumax ProLine PL70 8 сторінок. Heavy frameless bypass bath enclosure
Друкувати сторінку8
Fixed Panel Installation - Install the "peel-and-stick" Wall Seal [EE]
on the wall side edge of the Fixed Panel. Orient it with the open
end to the inside of the enclosure. Lift the Fixed Panel and set it in the
Glass Clips with the edge as tight to the wall as possible. Loosen the
Set Screws in the Wall Mount Sleeves and slide them over the Wall
Mount Blocks. Snug the Set Screws into the block (DO NOT TIGHTEN).
Loosen, but do not remove, the Glass Mount Screws and make sure the
Header Bar is still level, or has a slight tilt toward the door side. Small
adjustments in the Header Bar can be made with the Set Screws in the
Wall Mount Sleeves. Once you have the Header Bar set as you want
it, and the Fixed Panel positioned correctly, tighten the Wall Mount Set
Screws, then the Glass Mount Screws.
9
Door Panel Installation – Lift the Door Glass [P] and place the
rollers on the bar, making sure to get the bottom edge of the Door
Glass into the Center Guide. To adjust the Rollers, up or down, use the
adjustable wrench to loosen the roller and use a 5/32" Allen wrench to
turn the adjuster on the roller mounting plate. Turning the hole in the
adjuster plate to the down position will lower the glass, turning it to the
up position will raise the glass. CAUTION: DO NOT LET THE GLASS
FALL. Install the Anti-Jump by placing an Anti-Jump Plastic Washer
[FF] and the Anti-Jump Glass Insert [GG] over the Anti-Jump Main Shaft
[HH]. Insert through the hole in the door glass, below the bar from the
inside with the threaded end of the shaft pointing to the outside. Place
another Anti-Jump Plastic Washer, an Anti-Jump Spacer [I I], and thread
the Anti-jump End Cap [JJ] and Anti-Jump Sleeve [KK] onto the main
shaft. Adjust so that the Anti-Jump Sleeve and End Cap are as close to
the bottom of the bar as possible and tighten. Install the other Anti-Jump
assembly.
Page 8 of 9