Alumax Stickstall 794 Series Manuel d'instructions d'installation - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Alumax Stickstall 794 Series. Alumax Stickstall 794 Series 11 pages. Shower enclosure

Imprimer la page

- ALL DOORS

Cut four pieces of the smaller vinyl [FF] 1"

longer than the vertical opening (to prevent

gapping from shrinkage) and trim the ends on a

45° angle.

Using the masking tape guides, center

the glass panel [J] in the frame. Cut four short (1"

- 2") pieces of the small vinyl and press into both

jambs on each side to hold the glass temporarily.

Take one of the long pieces of vinyl, and starting

on the outside exterior jamb, press each end into

the frame and work toward the middle.

not to stretch the vinyl.

pieces in a similar fashion.

- ALL DOORS

Cut four pieces of the larger vinyl [GG] 1/2"

longer than the horizontal opening and trim the

ends on a 45° angle.

starting at both ends and working toward the

middle.

Be careful not to stretch the vinyl.

Install the top interior vinyl and the two bottom

vinyls in the same way.

- ALL DOORS

Carefully caulk the interior jamb-to-wall

and curb-to-base joints.

wish to caulk the exterior joints as well.

recommend you wait twenty-four hours before the

first shower to allow the caulking to cure properly.

EPH-N00-06003

5-20-97

Be careful

Install the other three

Install the top exterior vinyl

For appearance, you may

Page 10 of 11