Alumax Stickstall 794 Series 설치 지침 매뉴얼 - 페이지 10

{카테고리_이름} Alumax Stickstall 794 Series에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alumax Stickstall 794 Series 11 페이지. Shower enclosure

- ALL DOORS

Cut four pieces of the smaller vinyl [FF] 1"

longer than the vertical opening (to prevent

gapping from shrinkage) and trim the ends on a

45° angle.

Using the masking tape guides, center

the glass panel [J] in the frame. Cut four short (1"

- 2") pieces of the small vinyl and press into both

jambs on each side to hold the glass temporarily.

Take one of the long pieces of vinyl, and starting

on the outside exterior jamb, press each end into

the frame and work toward the middle.

not to stretch the vinyl.

pieces in a similar fashion.

- ALL DOORS

Cut four pieces of the larger vinyl [GG] 1/2"

longer than the horizontal opening and trim the

ends on a 45° angle.

starting at both ends and working toward the

middle.

Be careful not to stretch the vinyl.

Install the top interior vinyl and the two bottom

vinyls in the same way.

- ALL DOORS

Carefully caulk the interior jamb-to-wall

and curb-to-base joints.

wish to caulk the exterior joints as well.

recommend you wait twenty-four hours before the

first shower to allow the caulking to cure properly.

EPH-N00-06003

5-20-97

Be careful

Install the other three

Install the top exterior vinyl

For appearance, you may

Page 10 of 11