Aluprof AL-BR02 Manuel d'installation, d'assemblage et d'utilisation - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'installation, d'assemblage et d'utilisation pour {nom_de_la_catégorie} Aluprof AL-BR02. Aluprof AL-BR02 4 pages. Gate control unit
Imprimer la page
6. Programming of the first transmitter.
With the power on, press the PROG button which
will be confirmed by lighting of the LED.
* - In case of lack of ‚'P2'' button its function is performed by a combination of "STOP" and "UP" buttons.
7. Adding another transmitter
Press the „P2"* button
twice on a pre
programmed transmitter.
* - In case of lack of ‚'P2'' button its function is performed by a combination of "STOP" and "UP" buttons.
8. Deleting the transmitter.
Press the „P2" button*.
* - In case of lack of ‚'P2'' button its function is performed by a combination of "STOP" and "UP" buttons.
9. Erasing all of the transmitters..
Press the PROG button five times.
Each press must be confirmed by flash of the LED.
We reserve the right to any technical change.
Valid on 2021.11.29
Press the „P2" button * three
times on the new transmitter
Press „STOP" button
Press the "P2" * button
within 10 seconds.
Correct programming of the
transmitter will be confirmed by
a flash of the LED and
short UP - DOWN move.
Press the „P2" button*.
Acceptance of the settings will
be confirmed by a longer flash
of the LED.
Correct programming of the
transmitter will be confirmed by a
flash of the LED and
short UP - DOWN move.
Acceptance of the settings will
be confirmed by a flash of the LED
and short UP - DOWN
move.
3