Aluprof AL-BR02 설치, 조립 및 운영 매뉴얼 - 페이지 3

{카테고리_이름} Aluprof AL-BR02에 대한 설치, 조립 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aluprof AL-BR02 4 페이지. Gate control unit

6. Programming of the first transmitter.

With the power on, press the PROG button which

will be confirmed by lighting of the LED.

* - In case of lack of ‚'P2'' button its function is performed by a combination of "STOP" and "UP" buttons.

7. Adding another transmitter

Press the „P2"* button

twice on a pre

programmed transmitter.

* - In case of lack of ‚'P2'' button its function is performed by a combination of "STOP" and "UP" buttons.

8. Deleting the transmitter.

Press the „P2" button*.

* - In case of lack of ‚'P2'' button its function is performed by a combination of "STOP" and "UP" buttons.

9. Erasing all of the transmitters..

Press the PROG button five times.

Each press must be confirmed by flash of the LED.

We reserve the right to any technical change.

Valid on 2021.11.29

Press the „P2" button * three

times on the new transmitter

Press „STOP" button

Press the "P2" * button

within 10 seconds.

Correct programming of the

transmitter will be confirmed by

a flash of the LED and

short UP - DOWN move.

Press the „P2" button*.

Acceptance of the settings will

be confirmed by a longer flash

of the LED.

Correct programming of the

transmitter will be confirmed by a

flash of the LED and

short UP - DOWN move.

Acceptance of the settings will

be confirmed by a flash of the LED

and short UP - DOWN

move.