Artrom EA-Max Manuel d'instruction - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Artrom EA-Max. Artrom EA-Max 15 pages.

Imprimer la page

CLEANING AND MAINTENANCE

1. Always unplug the unit from mains power supply before attempting any cleaning or user

maintenance.

2. The water tank must be drained of any water after each use. To do so, carefully pull the water

tank out from the unit then hold a suitable vessel underneath to catch the water. Once the

water tank has been drained, wipe away any excess water with a soft cloth.

3. To clean the evaporation pad and mesh filter, pull them up and away from the back of the unit,

then wash them in warm water with a mild detergent and a soft brush. Take care not to pierce

the pad and filter.

4. Before replacing the evaporation pad and mesh filter, check the drain hole for any debris or

blockages and remove if necessary.

5. Wipe the unit with soft, damp cloth and dry thoroughly

6. Do not use flammable liquid, abrasive cleaning solvents, polishes or scouring pads to clean the

humidifier, as this may cause damage.

Please ensure that the unit and all of its parts are cleaned regularly to reduce the risk of limescale

and bacteria forming. The evaporation pad must be installed flatly, in order to avoid leaking.

Attention:

Must unplug the power plug when cleaning.

Don't make the water into the control panel.

The evaporation pad must be installed flatly, in order to avoid leaking.

MALFUNCITON AND MAINTENANCE

Malfuction

The unit will not

power on

The air blowing

from the

Max

EA-

is not strong

enough

Possible reasons

1.Power off , poor connection or not

connected to the main power supply

2.Not switch on the main switch e back

of body

3.The desired cooling or heating has

not been selected

4.The fuse has blown

1. The cooling speed is set too low

2. The mesh filter or evaporation pad is

blocked

Solution

1.Plug in and switch on the main

power supply.

2.Switch on the main switched

back of body.

3.Press any one of the buttons

by remote control or control

panel button

1.Select a higher cooling speed

by pressing the relevant cooling

speed button

2.Clean the mesh filter or

evaporation pad