Dockmate RXDOCKG Manuel d'installation - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dockmate RXDOCKG. Dockmate RXDOCKG 18 pages. Single-handed wireless remote control over your boat

Imprimer la page

8. Connecting the horn module

The first step of connecting the Dockmate to the boat is by connecting the horn

module.

Please note that when depressing the 'Horn'-button on the single and twin

transmitter, there will be a delay time of about 0,6 seconds.

The Dockmate Receiver may only be connected directly to the boat's

horn button when the boat's horn circuit has a built-in relay.

When the horn button is big, bulky and has very thick wire, that suggests

that no relay is used on the boat. In that case, wiring the Dockmate the

standard way can cause wires or relays to burn, since it can only switch up to 2-3A.

For boats without a built in horn relay, an additional relay must be used.

Dockmate can supply:

"09.03.02 – External Horn Relay – 12V"

"09.03.03 – External Horn Relay – 24V"

Alternatively, you can use a generic 12V relay (or 24V relay, depending on the boat).

You can easily check the need for an additional relay by using a multimeter.

Disconnect one wire from the horn button and set your multimeter for amps (10 or

20A range). Connect it as shown in the image below, and press the horn. When the

current is bigger than 3A, an External Horn relay has to be used.

VAT BE 0891.773.260 – Tel. +32 (0)15 43 39 94 – Mob. +32 (0)475 45 37 35

[email protected]

Dockmate is a registered trademark from PPA-Electronics B.V.

Leuvensesteenweg 177 – BE-3191 Boortmeerbeek – Belgium

–

www.dockmate.eu

–

[email protected]

–