Dockmate RXDOCKG Manuel d'installation - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dockmate RXDOCKG. Dockmate RXDOCKG 18 pages. Single-handed wireless remote control over your boat

Imprimer la page

10. Connecting the anchor winch

Most anchor winches are connected as shown below.

To find out which wire is which, use a voltmeter. Turn on the power of the windlass

(but don't press any buttons) and measure the voltage between the ship's ground

and the 3 pins of the windlass switch. The one that has +12 or +24V is the center one

and has to be connected to the red and black wires. Then measure the voltage on

the remaining wires by pressing the windlass button on the dashboard to find out

which wire is powered when you press the up or down buttons.

Be careful: the windlass will move when you press the buttons!

Connection for both anchors are the same.

To select which anchor is active (on the remote there is only one pair of IN/OUT

buttons) press both the (IN and OUT) buttons simultaneously for 0.5s on the

transmitter. It will beep twice for the first anchor and 4 times for the second anchor.

NOTE: On the transmitter, together with the beep, also the battery LED will blink 2 or

4 times depending on which windlass is selected.

In DockControl please select if Single or Double

anchor module is installed and used.

Direction of the buttons can be reversed for each

anchor.

Note : White and yellow wires must be left

unconnected.

Dockmate is a registered trademark from PPA-Electronics B.V.

Leuvensesteenweg 177 – BE-3191 Boortmeerbeek – Belgium

VAT BE 0891.773.260 – Tel. +32 (0)15 43 39 94 – Mob. +32 (0)475 45 37 35

[email protected]

–

www.dockmate.eu

–

[email protected]

–