DOD FX7 Manuel du propriétaire - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} DOD FX7. DOD FX7 18 pages. Dod guitar effects processor/preamp owner's manual fx7
Imprimer la page
Hooking Up
FX7 owner's manual
signal processing
DO NOT APPLY POWER TO THE FX7 UNTIL INSTRUCTED.
1)
STEREO: Connect the Left and Right outputs to a pair of guitar
amplifiers, or the inputs of a mixing console. If you're using guitar
amps, set the tone controls flat (no boost or cut) and balance the
levels between them. If you're using a console, pan the FX7 input
channels hard left and right, and turn down the high frequency
EQ for best results.
MONO: Connect the Left output to a guitar amplifier or input of a
mixing console.
2)
Connect your instrument to the input of the FX7.
3)
OPTIONAL: Connect a volume type or 0/+5v controller pedal to
the Controller input of the FX7. Make sure the pedal is connected
before you apply power to the FX7.
4)
Power up the FX7 by connecting the supplied AC adapter
between the FX7 and a power outlet.
5)
Play your instrument and watch the Clip LED on the FX7 carefully
as you set the Input knob. Turn up the input level until the Clip
LED begins to light, and reduce the input level slightly. When the
Input knob is set properly, the Clip LED should not flicker on the
loudest passages.
6)
Set the output level as desired.
7