DOD FX7 소유자 매뉴얼 - 페이지 9

{카테고리_이름} DOD FX7에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DOD FX7 18 페이지. Dod guitar effects processor/preamp owner's manual fx7

FX7 owner's manual

signal processing

DO NOT APPLY POWER TO THE FX7 UNTIL INSTRUCTED.

STEREO: Connect the Left and Right outputs to a pair of guitar

amplifiers, or the inputs of a mixing console. If you're using guitar

amps, set the tone controls flat (no boost or cut) and balance the

levels between them. If you're using a console, pan the FX7 input

channels hard left and right, and turn down the high frequency

EQ for best results.

MONO: Connect the Left output to a guitar amplifier or input of a

mixing console.

Connect your instrument to the input of the FX7.

OPTIONAL: Connect a volume type or 0/+5v controller pedal to

the Controller input of the FX7. Make sure the pedal is connected

before you apply power to the FX7.

Power up the FX7 by connecting the supplied AC adapter

between the FX7 and a power outlet.

Play your instrument and watch the Clip LED on the FX7 carefully

as you set the Input knob. Turn up the input level until the Clip

LED begins to light, and reduce the input level slightly. When the

Input knob is set properly, the Clip LED should not flicker on the

loudest passages.

Set the output level as desired.