Dogtra E-Fence 3500 Manuel du propriétaire - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Dogtra E-Fence 3500. Dogtra E-Fence 3500 16 pages.

Testing Your Dogtra E-Fence 3500 Prior

to Installation

2. Unwind the length of ground wire that was provided and strip

about 1/2 inch off each end. Insert both ends of the ground wire

into the outer, red wire connector jacks, leaving the center jack

free. If the wires are connected properly, the wire indicator light

will be on.

3. Next, activate the receiver/collar by turning the intensity level

dial on the receiver to the desired level. The LED light will

blink once every two seconds showing that it is on.

* If not activated for 10 seconds or more, the system will go

into sleep mode.

4. Hold the receiver in your hand with the contact points facing

up. Place the test lamp over the contact points and approach

the test loop.

5. Watch for the test lamp to come on and the unit to vibrate.

Be careful not to touch the contact points as the unit will emit

stimulation when activated.

1. To ensure that your E-Fence

3500 system is working

properly, connect the power

adaptor into the transmitter

power jack and then plug the

power adaptor into a household

outlet. Switch the stimulation

knob to Pager + Stimulation,

or Pager Only. The On/Off

indicator light should turn on.

Fence Wire

The e-fence boundary wire must make a continuous loop around

your property for the system to operate. The signal is delivered

from the terminal of the transmitter, through the fence wire, back to

the other terminal on the transmitter. When this is accomplished,

the wire continuity light will emit a constant red indicator.