Akrobat GALLUS Manuel d'installation et d'utilisation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Akrobat GALLUS. Akrobat GALLUS 14 pages.

Installation of the safety net
Start assembling the safety net by inserting
8*
the enclosure pole attached to the door (Part R)
into the frame part with T-socket.
Insert the bottom part of the door and start
unrolling the safety net around the mat. Make
sure the net is not twisted. After unrolling the
entire net, insert the final pole in the socket
next to the door - be sure to close the door on
the inside of the trampoline before inserting
the last pole.
Start inserting the first pole left from the door.
9
Keep the bottom edge of the net stretched
before inserting the next enclosure pole. Take
the net near the door and pull tightly towards
the first pole before inserting the pole through
the net and into the socket.
Continue by inserting all of the enclosure poles
10
through the netting into the sockets, all the
way stretching the bottom edge of the net,
in order to make sure that the safety net goes
tightly around the trampoline.
AKROBAT HINT:
If you find the netting too short or too long
towards the end, adjust the entire netting
starting from the door towards the last
pole.
After installing all the poles start assembling
11*
the top frame. Take the shorter top frame
part with a hole in the middle (Part G). This
pole should be attached above the door and
tightened with the connector screw into the
top of the enclosure pole.
Continue by attaching two top frame parts
together, then taking a connector screw and
tightening it into the top of the enclosure pole.
Important:
There are two sizes of top frame parts
– alternate them according to the
frame legs above which the longer
top frame parts should be placed.
12
INSTALLATION AND USER MANUAL - GALLUS
Now hang the top edge of the net around
12
the connector screws. In order to come all the
way around the frame stretch the netting the
same way as while attaching the bottom part.
Take the black 5 mm (part S) rope and web it
13
loosely around the top rail and the net. Web the
rope through every 4th hole on the top edge
of the net. Then return to the beginning and
tighten the rope, tying it around the screw on
the last enclosure pole.
Next, take the protection foam and place it
14*
on the top rail to form a full circle. Follow by
covering with the top PVC skirt (Part U), tying
it with the black rope (Part V). Attach the cord
around the last screw.
Finally, attach the bottom edge of the netting
15
to the frame and around the spring with the
remaining toggle elastics.
13