Akrobat GALLUS Installatie- en gebruikershandleiding - Pagina 7

Blader online of download pdf Installatie- en gebruikershandleiding voor {categorie_naam} Akrobat GALLUS. Akrobat GALLUS 14 pagina's.

Pagina afdrukken

Installation of the safety net

Start assembling the safety net by inserting

the enclosure pole attached to the door (Part R)

into the frame part with T-socket.

Insert the bottom part of the door and start

unrolling the safety net around the mat. Make

sure the net is not twisted. After unrolling the

entire net, insert the final pole in the socket

next to the door - be sure to close the door on

the inside of the trampoline before inserting

the last pole.

Start inserting the first pole left from the door.

Keep the bottom edge of the net stretched

before inserting the next enclosure pole. Take

the net near the door and pull tightly towards

the first pole before inserting the pole through

the net and into the socket.

Continue by inserting all of the enclosure poles

through the netting into the sockets, all the

way stretching the bottom edge of the net,

in order to make sure that the safety net goes

tightly around the trampoline.

AKROBAT HINT:

If you find the netting too short or too long

towards the end, adjust the entire netting

starting from the door towards the last

pole.

After installing all the poles start assembling

11*

the top frame. Take the shorter top frame

part with a hole in the middle (Part G). This

pole should be attached above the door and

tightened with the connector screw into the

top of the enclosure pole.

Continue by attaching two top frame parts

together, then taking a connector screw and

tightening it into the top of the enclosure pole.

Important:

There are two sizes of top frame parts

– alternate them according to the

frame legs above which the longer

top frame parts should be placed.

INSTALLATION AND USER MANUAL - GALLUS

Now hang the top edge of the net around

the connector screws. In order to come all the

way around the frame stretch the netting the

same way as while attaching the bottom part.

Take the black 5 mm (part S) rope and web it

loosely around the top rail and the net. Web the

rope through every 4th hole on the top edge

of the net. Then return to the beginning and

tighten the rope, tying it around the screw on

the last enclosure pole.

Next, take the protection foam and place it

14*

on the top rail to form a full circle. Follow by

covering with the top PVC skirt (Part U), tying

it with the black rope (Part V). Attach the cord

around the last screw.

Finally, attach the bottom edge of the netting

to the frame and around the spring with the

remaining toggle elastics.