DogWatch Performance Series Manuel du propriétaire - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} DogWatch Performance Series. DogWatch Performance Series 13 pages. Hidden fence systems
Également pour DogWatch Performance Series : Manuel du propriétaire (14 pages), Manuel d'installation (10 pages), Manuel du propriétaire (16 pages)
Imprimer la page
How the DogWatch System Works
The boundary wire creates the perimeter for the DogWatch Hidden Fence System, and can
enclose any area up to 200 acres. It is buried at least 3 – 4" beneath the surface of the yard
or can lie on top of the ground (e.g.: in wooded or rocky areas). It can also be installed
around gardens or swimming pools, or attached to an existing fence to prevent your dog
from digging under or jumping over it.
Boundary Wire
Signal Field
Garden Loop
Boundary Wire: The boundary wire carries the coded FM radio signal around the
perimeter of your property. It is rated for underground burial.
Signal Field: The radio signal is transmitted from the boundary wire in all directions. It
can be used to keep dogs in or out of an area. The signal is adjusted by the Range
control on the Transmitter to create a signal field on each side of the wire. Your Dealer
has installed the wire to the recommended width of 8-10 feet and has carefully
configured the corners to avoid sharp angles.
Continuous Loop: In order for the system to work properly, the boundary wire must
form a continuous loop. Any break in the wire will cancel the signal field. If the
boundary wire is broken or unplugged, the green Loop Monitor Display (LMD) light
will go out and an audible warning will sound. Most breaks are caused by lawn/garden
equipment. If you cannot visibly locate the break, contact your Authorized Dealer for
service.
Surge Protector: For maximum protection against power surges, ogWatch offers
both internal an external surge protection. It is important that the surge protector
be properly grounded. This part of the system protects the transmitter from damage
due to lightning power surges. Your Dealer has attached it to the existing electrical
source house ground or a grounding rod and then connected it to the twisted wire
between the transmitter and the boundary wire.
After a lightning storm, check to be sure your transmitter is working properly.
Do not let your dog outside until you know the system is operating.
Twisted Wire
Transmitter
& Surge
Protector
10
How The DogWatch System is Installed
Transmitter
PowerPak
(optional)
Ground Wire
Power
Supply
Boundary Wire
DogWatch System Components
PT4 Transmitter
Surge Protector
A
D
R7 Receiver or
Training Leash
B
E
R8 Receiver
Power Supply
C
F
and Nylon Collar
F
D
G
E
Outside Wall
Inside Wall
Surge
Protector
Zip Cord
Ground Wire
Ground
Twisted Wire
Test Magnet/Light
G
Collar Wrench
H
PowerPak™ (Optional)
I
A
H
B
C
11
Rod
I