ASG ASG-D35 Manuel d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} ASG ASG-D35. ASG ASG-D35 10 pages. Mini digital torque wrenches and screwdrivers

Imprimer la page

1. Specifications

ASG Mini Digital Torque Wrenches and Screwdrivers

Operation Manual

Installing the Battery

Remove the battery cap by turning counter clockwise using a coin. Insert one AAA

battery matching the +/- polarity of the battery to the battery compartment.

To install the battery cap, with the display facing up, start with the small mark on the

battery cap at the 6 o'clock position then turn clockwise to approximately the 8 o'clock

position. If a known good battery is installed with the proper polarity and the tool does

not operate remove and rotate the cap 180o and reinstall.

CAUTION: Do not over tighten the cap. If the cap is installed in

the correct position, and the tool still does not work, check to

make sure the metal contact and spring are in place in the cap.

The part number for a replacement cap is #728084.

ASG, Division of Jergens, Inc.

S. Waterloo Road | Cleveland, OH

15700

44110-3898

| Phone: (

| Fax: (

| Email: [email protected] | Web: www.asg-jergens.com | Revision: 11/14/2019 | Page 3 of 10

888) 486-6163

216) 481-4519

Display and Button Functions

All programming is done with the buttons on the face of the tool.

1. Button #1 is the CLEAR /RESET button. Press "C" to turn the tool on or reset

the torque in peak mode. The tool will auto shut off after several minutes of

inactivity.*

2. Button #2 is the UNIT/SET button. Press "U/S" to change the engineering units,

enter program mode or advance while in program mode.

3. Button #3 is the MEMORY button. Press the "M" button to select memory preset

or store the reading in peak mode.

4. Buttons #4 are the UP/DOWN buttons. Press the UP/DOWN buttons to increase or

decrease the torque reading seen on the display, or to select a program option.

•

The GREEN LED will light up when the applied torque reaches 90% of the

TARGET TORQUE. The BUZZER will also beep intermittently. When the applied

torque reaches 99.5% of the target torque, the GREEN LED will remain lit and the

BUZZER change to a steady tone.

•

The RED LED will light up when the applied torque reaches 99.5% of the target

torque.

•

* When [SEnd ] is seen on the display auto shut off is canceled.