CYP COH-Tx Manuel d'utilisation - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} CYP COH-Tx. CYP COH-Tx 12 pages. Hdmi to optical transmitter and receiver
Également pour CYP COH-Tx : Manuel d'utilisation (16 pages)
Imprimer la page
7. Operation Controls and Functions
7.1 Transmitter
Front Panel
ERROR
HDMI LINK
①
② ③
① HDMI LINK: This LED will illuminate in blue when at least one optical cable
is connected and has successfully detected and communicated
between Tx and Rx with video or audio data sending.
② ERROR: This LED will illuminate in red when there appears to be an error in
the input signal data rate that is higher than 75MHz or the HDMI output is
not output able.
③ HDMI INPUT: This slot is to connect with an input source such as a DVD or
Blu-Ray player with HDMI cable.
④ OPTICAL LINK: This LED will turn illuminate in blue when the optical cable is
connected and has successfully detected and communicated between
Tx & Rx with data sending. If the LED is not illuminate users need to check
the connection of the fiber cable and then make sure the connection
is well and the cable itself is good.
⑤ OPTICAL: Connect both ends of the fiber optical cable to each side of
the device in order send a signal.
Note: Connector Type: LC-LC, Fiber: Duplex Multi-mode Fiber
⑥ DC 5V: Plug the 5V DC power supply into the unit and connect the
adaptor to an AC outlet. The LED will switch on when the power cable is
plugged in.
HDMI
OPTICAL
INPUT
LINK
④
Rear Panel
OPTICAL
⑤
3
DC 5V
⑥