CYP COH-Tx 운영 매뉴얼 - 페이지 7

{카테고리_이름} CYP COH-Tx에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CYP COH-Tx 12 페이지. Hdmi to optical transmitter and receiver
CYP COH-Tx에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지)

페이지 인쇄

7. Operation Controls and Functions

7.1 Transmitter

Front Panel

ERROR

HDMI LINK

①

② ③

① HDMI LINK: This LED will illuminate in blue when at least one optical cable

is connected and has successfully detected and communicated

between Tx and Rx with video or audio data sending.

② ERROR: This LED will illuminate in red when there appears to be an error in

the input signal data rate that is higher than 75MHz or the HDMI output is

not output able.

③ HDMI INPUT: This slot is to connect with an input source such as a DVD or

Blu-Ray player with HDMI cable.

④ OPTICAL LINK: This LED will turn illuminate in blue when the optical cable is

connected and has successfully detected and communicated between

Tx & Rx with data sending. If the LED is not illuminate users need to check

the connection of the fiber cable and then make sure the connection

is well and the cable itself is good.

⑤ OPTICAL: Connect both ends of the fiber optical cable to each side of

the device in order send a signal.

Note: Connector Type: LC-LC, Fiber: Duplex Multi-mode Fiber

⑥ DC 5V: Plug the 5V DC power supply into the unit and connect the

adaptor to an AC outlet. The LED will switch on when the power cable is

plugged in.

HDMI

OPTICAL

INPUT

LINK

④

Rear Panel

OPTICAL

⑤

DC 5V

⑥