Doka 586231000 Mode d'emploi original - Page 5

Parcourez en ligne ou téléchargez le pdf Mode d'emploi original pour {nom_de_la_catégorie} Doka 586231000. Doka 586231000 5 pages. Dokamatic lifting strap 13.00m

Imprimer la page
Original Operating Instructions Dokamatic lifting strap 13.00m
Lifting single tables
The integrated strap shoes are not pushed onto the
secondary beams. This makes it possible to operate
the Lifting strap 13.00m when working from ground
level.
The strap shoes can either remain on the strap, or be
detached from it as needed.
B Strap shoes
9767-265-01
NOTICE
It is only allowed to lift one table at a time in
each crane cycle!
WARNING
Risk of intermediate props dropping out
when table is lifted
➤
Intermediate props with a Supporting head
H20 DF, and props that are only secured
against tipping over, must be removed
before the table is lifted.
➤
Intermediate props that are attached by an
Intermediate head DF and that are not dis-
mounted must be pulled in sufficiently far.
WARNING
➤
"Passenger transportation" is forbidden!
➤
Before repositioning the tableform, remove
any loose items (e.g. fitting-boards) from it.
➤
Check the connections between the floor
props and the table before repositioning it.
999265002 - 12/2017
B
9265-204-01
NOTICE
Tables with pre-mounted edge strips or
covered in sheeting across entire width.
A nailed-on plank (approx. 15 x 5 x 60 cm) pre-
vents the lifting strap damaging or breaking off
the edge strip.
e ... approx. 1.0 cm
A Dokamatic lifting strap 13.00m
C Edge strip
D Plank

Declaration of Conformity

EC Declaration of Conformity
pursuant to EC Directive 2006/42/EC.
The manufacturer declares that by reason of its conception and
design, the following product
Dokamatic lifting strap 13.00m, Art. n° 586231000
Dokamatic lifting strap 13.00m SN, Art. n° 586231500
conforms – in the version marketed by ourselves – to the pertinent
fundamental health and safety stipulations of the relevant EC Direc-
tives.
The following harmonised standards were applied:
▪
EN ISO 12100:2010
▪
EN ISO 12100-2:2009
▪
EN 349:1993+A1:2008
▪
EN 1492-1:2000+A1:2008
Person authorised to compile technical documentation
(pursuant to European Directive on Machinery Annex II):
Dipl.-Ing. Ludwig Pekarek
Josef Umdasch Platz 1
A-3300 Amstetten
Amstetten, 06/11/2017
Ludwig Pekarek
Executive Manager
A
C
e
D
Doka GmbH
Josef Umdasch Platz 1
A-3300 Amstetten
Dipl.-Ing. Peter Reisinger
Authorised Officer, Head of Engi-
neering
5