Dolphin BC 2012 Manuel de l'utilisateur - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dolphin BC 2012. Dolphin BC 2012 12 pages. Automatic velocity hand dryer
Imprimer la page
Cleaning the air filter
Use a vacuum cleaner to remove any dirt from the filter.
If the filter is very dirty, wash it carefully in cold or warm water.
Allow the filter to dry and replace.
Make sure that the air filter is all the way in. (If it is not located
correctly dirt or dust will enter the dryer and shorten its service
life).
Hand dryer troubleshooting
If the following problems occur, please perform checks as follows.
Problem
No air blows even if hands
are inserted
The unit does not stop
blowing once hands are
removed display shows E2
Airflow is too low
If the above actions do not work, turn off the power supply, isolate the dryer, them call a
service engineer.
Display screen indicator lights and functions
Power indicator light
When power input is normal, this light will light and stay on.
If the light is out, power supply is not on. Or the fuse on the main circuit board has blown.
(Check power supply or call service engineer),
State indicator light
When the light is on the unit is working. When the light is out the unit will not work.
If this light is flashing is could be.
1. A motor fault (Check motor connecting wires or motor impeller for foreign material).
2. Working time of the dryer is longer then 25 seconds. (check/clear hand drying area for
foregin materials). Restart dryer.
BC 2012 User Manual
Check
Do any of the display
indicators light up?
Is the power switch on?
Are you putting your hands in
all the way?
Is the sensor being blocked
by dust or dirt?
Is the speed button set to the
low level?
Action
Turn the circuit breaker/RCD
on.
Turn the power switch on.
Put hands in all the way.
Turn the power switch off, and
then, after all the lamps in the
display have gone off, clean
the sensor.
Put speed button on the high
level.
www.dolphindispensers.co.uk