Cytech MN-GSM Manuel de démarrage rapide - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cytech MN-GSM. Cytech MN-GSM 9 pages.

Relative Humidity: < 95 % RH non condensing

•

U2 EEPROM 24LC256 (256 K Bits) for storage of parameters (use Comfigurator)

•

Equipment

The following equipment is required

Comfort CM9001 with firmware version 7.153 or higher.

•

Comfigurator version 3.13.7 and above

•

UCM/4G Firmware 7.164 and above

•

SIM Card

A Nano- SIM Card must be used in the GSM Module. This may be a prepaid or

postpaid card. However, note that a prepaid card does not inform the user

when the amount remaining has been used up. The SIM card or plan must

allow sending of SMS. Push/Insert the SIM Card with the edge woth slanted

corner first into the SIM Card holder. Remove by pulling the SIM Card out in the

oppositte direction.

Caller ID must be enabled to allow the GSNM Module to accept SMS commands

froma mobile phone.

If using a prepaid SIM card, check if the SIM card needs to be activated before

use. Please check the instructions from the Carrier.

The SIM card must not be password-protected.

•

The SIM card will come with a telephone number. Use this number to dial or

send SMS to the system via the GSM module

What is Included

The UCM/4G package contains the following*:

UCM/4G module with GSM submodule. T

•

5-way audio cable

•

4-way RS485 cable

•

UCM/4G Quick Start Guide