Cytech MN-GSM Quick Start Manual - Page 2
Browse online or download pdf Quick Start Manual for Control Unit Cytech MN-GSM. Cytech MN-GSM 9 pages.
Print Page
Relative Humidity: < 95 % RH non condensing
•
U2 EEPROM 24LC256 (256 K Bits) for storage of parameters (use Comfigurator)
•
Equipment
The following equipment is required
Comfort CM9001 with firmware version 7.153 or higher.
•
Comfigurator version 3.13.7 and above
•
UCM/4G Firmware 7.164 and above
•
SIM Card
A Nano- SIM Card must be used in the GSM Module. This may be a prepaid or
postpaid card. However, note that a prepaid card does not inform the user
when the amount remaining has been used up. The SIM card or plan must
allow sending of SMS. Push/Insert the SIM Card with the edge woth slanted
corner first into the SIM Card holder. Remove by pulling the SIM Card out in the
oppositte direction.
Caller ID must be enabled to allow the GSNM Module to accept SMS commands
froma mobile phone.
If using a prepaid SIM card, check if the SIM card needs to be activated before
use. Please check the instructions from the Carrier.
The SIM card must not be password-protected.
•
The SIM card will come with a telephone number. Use this number to dial or
send SMS to the system via the GSM module
What is Included
The UCM/4G package contains the following*:
UCM/4G module with GSM submodule. T
•
5-way audio cable
•
4-way RS485 cable
•
UCM/4G Quick Start Guide
2