BluePoint Fasteners GT-100L Manuel de sécurité et d'utilisation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de sécurité et d'utilisation pour {nom_de_la_catégorie} BluePoint Fasteners GT-100L. BluePoint Fasteners GT-100L 13 pages. Gas concrete nailer

Imprimer la page

GENERAL OPERATION MANUAL

NOTE :

The information contained in this Manual is designed to assist you in the safe operation of the Nailer.

Some illustrations in this Manual may show details or attachments that differ from those on your own

Nailer.

NAME OF PARTS

1. Gas Concrete Nailer ( MODEL: GT-100L)

Top Cover

Piston

Piston Assembly

Magazine

Firing Head

2. Battery Pack

Terminal

3. Battery Charger

Battery Installation

Pilot Lamp

Fuel CellBase

Fuel Cell

Handle

Battery Pack

Lock-screw

Nail Feeder

Latch

Battery Pack

Power Plug

Power Cord

Air Vent

4. Accessories

DANGER

Accessories other than those shown below can lead

to malfunction and resulting injuries.

STANDARD ACCESSORIES

1.Allen Wrench for M5 Screw ···························· 1

2.Lubricant Oil···················································· 1

3.Battery ····························································

4.Charger ···························································

OPTIONAL ACCESSORIES

sold separately

1.Fuel Cell

2.Cleaner

(Code No. 00091800)

APPLICATIONS

Suggested applications on work pieces with

substrate connection combination:

Metal (sheet, section and wire netting etc.), wood,

engineering plastics, plywood and nail accessory

separate connection with concrete, brick setting,

metal plate.

REMOVAL AND INSTALLATION METHOD OF

BATTERY

Handle

Latch

Battery Pack

pull out

insert

1. How to install the battery

Align the battery with the groove in tool handle

and slip it into place. Always insert it all the way

until it locks in place with a little click. If not, it

may accidentally fall out of the tool, causing

injury to you or someone around you.

2. How to remove the battery

Withdraw battery from the tool handle while

pressing two button on the side of the battery.

CHARGING METHOD

NOTE : Before plugging into the receptacle, make

sure the following points.

■ The power source voltage is stated on the nameplate.

■ The cord is not damaged.

WARNING

Do not charge at voltage higher

than indicated on the name plate.

If charged at voltage higher than

indicated on the nameplate, the

charger will burn up.

■ Do not use the electrical cord if damaged.

Have it repaired immediately.

■ Use only recommended type of charger

(00091301) and battery pack (00091001), if

not, may cause the charger damage or

battery burst.

STEP:

1. Insert the battery into the charger base. Make

sure it contacts the bottom of the charger base .

2. Insert the connection plug of adapter into the

receptacle of the charge base.

3. Insert the power plug of the adapter into the

plug seat.

4. Charging

■ When the plug of charger adapter has been inserted

into the plug seat , charging will commence and the

red pilot lamp will light on .

NOTE : If the green pilot lamp light on , this means

the battery is filled or the battery excess

temperature. If the battery excess temperature,

wait until battery cold then charging.

■

In approx. 120 min. at 70°F (20°C), when the

battery is fully charged, the red pilot lamp will

go out and the green pilot lamp will light on .