Ambiente WF3622 Instructions d'installation - Page 2
Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Ambiente WF3622. Ambiente WF3622 2 pages. Ammonite curly swirly water feature small & large
Installation Instruction
Step 1 – Plastic reservoir
Place reservoir on a level surface at the
desired location.
Step 2
Using the tube connector at the rear
of the feature, connect tubing to water
pump and the feature.
Step 3
Place grid onto reservoir.
Step 4
Screw feature to grid.
Step 5
Fill reservoir with clean water and
ensure pump is fully submerged.
Step 6
Connect the power cable, wait until
trapped air has worked its way out of
the pump.
As this pump is water
cooled, allowing it to
run dry may result in
the pump burning out,
invalidating the warranty.
DO NOT allow the pump to run dry!
3
6
5
1
Stainless Steel Reservoir
4
See plastic reservoir instructions 1–6,
the main difference is that you won't be
screwing the feature into place (3&4).
2
Stainless Steel Maintenance
2
When maintaining your feature, it is important to adhere to the following points:
Important – Always use Ambienté fountain safe (see reverse of this leaflet) when filling the feature with
water or just topping up the water level.
Do not use any other chemical water treatments such as salt water.
We do not recommend the use of fish or water plants with your stainless steel feature.
Do not use chlorine or bleach to clean the feature.
Warning – Always unplug the pump while cleaning the feature.
Should the pump cable or pump become damaged. You will need to replace the pump as the cable can
not be replaced.
If you need to replace the pump please refer to the original pump and use the same specification as per
the original order.
Remember – This feature will require maintenance.
Use non-abrasive soft cloths with clean water or a glass and hard surface cleaner to wipe over the
surfaces. Abrasive polishes and cloths will scratch the finish.
The Ammonite (Curly Swirly)
Water Feature Small & Large
2
6
2
5
1