Ambirad TORNADO Manuel d'installation et d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Ambirad TORNADO. Ambirad TORNADO 16 pages. Gas fired mobile heater
Également pour Ambirad TORNADO : Manuel d'instruction (8 pages)

Imprimer la page

Installation Requirements.

2.1 Gas leaks

Propane gas is highly flammable and heavier than

air. Consequently in the event of a gas leak there

is a risk of explosion.

Prior to use, check gas supply connections with

leak detection solution. Never use a naked flame

when checking for a gas leak. In the event that

bubbles are noted either rectify if considered

competent or consult your supplier.

Do not use the heater until the fault is rectified.

In the event of a gas leak evacuate people from

the immediate area and open doors and windows.

Do not operate electrical switches.

If you suspect a large amount

escaped - call the Fire Service immediately.

After ventilating the room turn off the gas valve,

and disconnect the electrical connector to the

heater.

If the appliance is hot leave to cool then with the

aid of a competent person identify and rectify the

source of the leak.

2.2 Gas cylinders

This heater is designed to be used with at least

two 47kg propane bottles.

Technical details.

3.1 Dimensions

Gas cylinders are heavy, never attempt to lift a

cylinder, full or empty, by yourself. Always get

help.

Keep cylinders upright at all times during use,

transporting and when stored.

Liquid gas can cause severe freeze burns so

avoid skin contact by wearing gloves when

making connections or handling the cylinder. If ice

is noted on the cylinder ensure it is not leaking. If

leaking is suspected do not use the cylinder.

Do not drop or knock a gas cylinder as damaged

cylinders can be dangerous.

Do not store full or empty bottles in the operating

area of the heater and never apply heat to the

cylinder.

of gas has

2.3 Electrical supply

The heater is suitable for use with either a

230V/50Hz or 110V/50Hz supply. A selector

switch enables the user to choose the desired

voltage. See section 4.2.

Only female electrical connectors compatible to

the male connectors on the rear of the unit must

be used.

Always switch off and unplug the equipment when

not in use.

3.2 Technical Data

Heat input gas

Gas type

Gas category

Supply pressure

Nozzle pressure

Injector size

Electrical supply

Electrical input

Weight

Hose (Ambi-Rad

Part No 201308

Regulator

Min Room size

Req'd ventilation

*approved to EN 1763-1 BS3212 (UK Only)

Propane G31

I3p(37)

I3p(30)

mbar

16.0

7x1.8

230/110

400

1.2m lg, 10mm ID*

kg/h

mbar

510

cm2

1275