ACR Electronics Earlswood EW1MF Panduan Teknis - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Teknis untuk Kompor ACR Electronics Earlswood EW1MF. ACR Electronics Earlswood EW1MF 12 halaman. Multifuel stove

Halaman Cetak

Location of the unit

Clearances to non-combustible materials

There must be a minimum clearance of 150mm at each side of the

appliance. A clearance of 150mm is required at the back of stove (if the

rear wall has a thickness of 200mm or more this measurement can be

reduced to 50mm) A minimum clearance of 150mm is required above the

appliance.

Clearances to combustible materials

There must be a minimum clearance of 450mm at each side and 750mm at

the rear of the appliance from any combustible materials. If using single

wall flue pipe, there must be a clearance of at least 3 times the diameter of

the flue pipe (e.g 125mm diameter pipe = 375mm minimum clearance)

from any combustible materials e.g wooden beam.

Curtains and soft furnishings should be a minimum of 1m away from the

appliance.

Adequate space should be provided for servicing the appliance.

We do not recommend that plasma televisions and expensive artwork are

hung over the fireplace.

Please remember that this appliance has been designed to provide heat

and if installed into a recess enough space should be left around the

appliance to enable the heat produced to rise and escape from the recess

back into the room.

Hearth Requirements

The appliance must stand on a level fireproof hearth with a minimum

thickness of 12mm. The hearth temperature created by this stove is below

100˚C. The hearth must protrude at least 300mm in front of the appliance

and 150mm either side of the appliance.

The appliance shall be installed on a floor with an adequate load bearing

capacity. If an existing construction doesn't meet with prerequisite, suitable

measures (e.g. load distributing plate) shall be taken to achieve it.